Atomic powersuply AT-1A

Atomic powersuply AT-1A

379,00

 

The mighty Atomic Isolated Power Supply was developed to meet the high power requirements of Effectrode tube effects pedals. Properly designed tube pedals require much more power than solid-state effects because of the tube heaters and high voltage operation. To get an idea take a look at the size of the transformers inside a vintage or boutique tube amp. The Atomic supplies a massive 6 amps – enough energy to power up to four of our tube pedals without compromising tone quality.

Features

 

 

In stock

Categories: ,

Description

 

 

 

Features

Delivers a massive 6 amps at 12 Volts D.C. output for powering up to 4 vacuum tube effects
Incredibly clean smoothed and regulated studio quality power supply
Supplied with country-appropriate IEC power cable
Operates anywhere in the world from 110-250VAC. No more step up or step down transformers.
Solid diecast aluminium case
Fully isolated outlets completely eliminate earth loop hum
Short circuit/overload protection protects your tube pedals
One of the outputs can be configured to power 9V centre negative pedals (see note below)
Compatibility List

The Atomic is compatible with all Effectrode pedals (miniature and subminiature). It has also been tested with the following pedals by other manufacturers:

Empress Super Delay (12V center +ve)
Redwitch Titan Delay
Providence Chrono Delay (12V center -ve)
Kinglsey Bard (9V)
Vertex Axis Wah (9V)
Chicago Iron Octavian
I’ll add to this list as we and our customers test other pedals out.

WARNING!!! Before removing the rear panel of this Atomic, completely isolate it from the mains by disconnecting the mains power cable as there are hazardous voltages within this unit which could cause injury or death. If you are uncertain about what you are doing please seek advice from a properly qualified electrical engineer.350